Segway Personal Transporter i2 - When to Replace

4‐2 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
FASTENERS
• Use only Segway-approved fasteners.
• Do not tighten or reuse any fastener except the screws used to
attach the battery packs, wheel nuts, and LeanSteer frame.
Instead, when any other fastener is loose or removed, replace
the fastener with a new Segway-approved fastener. See
Appendix C, ”Fasteners” for more information.
• Do not attempt to repair any stripped or damaged screw hole.
Instead, replace the part. If replacement part is not available,
do not reassemble.
• Insert fasteners slowly and carefully. Do not cross-thread or
over-tighten fasteners. Tighten only to the prescribed torque.
• Failure to adhere to these warnings could lead to serious injury
or death or damage to property.
x2TurfSpacer(21370‐00001)
(1)Spacer
(4)Fasteners,40mm
i2TubeReplacementKit(21193‐00001)
(5)Tubes
i2TireReplacementKit(21471‐00001)
(5)Tires
Required Tools
• Torquewrench,3/8ʺdrive
• Hexsocketwrench,13mm
• Hexwrench,8mm
• 3‐in.3/8ʺdrivesocketextension(Model
x2)
• AirpumpwithSchradervalve
attachment
• Lowpressureinflationgauge
• Tireirons(2),motorcycletype
• Barclamp(tobreaktirebead)
When to Replace
Youneedtoreplaceatire/wheel
assemblyorthetiretube(modeli2)
underanyofthefollowing
conditions,including,without
limitation:
• Persistentleakintireafter
reinflation
• Wheeliscrackedorbent
• Tireisflat,cracked,or
excessivelyworn.Excesswearis
determinedasfollows:
• Modeli2—Centerribis
wornflushwi
thtiresurface
• Modelx2—Diamond
patternoncenterribisno
longervisible
• Modelx2Turf—Tiretread
depthislessthan3/32”
(2.38mm)
Tireinflationpressurecan
dramaticallyaffectrangetraction
andtreadwear.Ensuretiresare
properlyinflatedasfollows:
• (Modeli2)15psi(1.03bar)
• (Modelx2)4psi(.275ba
r)