Segway Personal Transporter i2 - User Interface Console (UIC) Removal and Installation

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 9‐9
User Interface Console (UIC) Removal and Installation
AllelectroniccomponentsintheSegwayPTare
redundant(AandB)forsafety.TheAandB
connectorsaredifferentlysizedtoensure
properconnectionwheninstalling.TheUIC
containstheconsoleradioandchargeport
powersupply.
If no Hi-Pot and Ground Bond Tester is available,
the removal and installation of the UIC should
not be performed as the consequence of not
being able to test could lead to serious injury,
death, and/or damage to the Segway PT.
When to Replace
ReplacetheUICwhendirectedtodosobya
SegwayServiceRepresentative.
Theconsoleradioiselectronicallybo
undtothe
otherelectronicsinsidethepowerbaseandthe
WirelessInfoKeycontroller.Replacementofthe
UICassumesinteractionwithG2SART.
To remove UIC:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Re
moveconsolecover(page9‐4).
3. Us
eT‐206‐lobewrenchtoremove(4)
fastenersholdingUICtoconsolehousing.
4. Use2.
5mmhexwrenchtoremove(2)M2.5
fastenersfromrearoneithersideofcharge
port.SeeFigure9‐9.
Figure9‐9:RemoveorInstallUIC
5. SlideIECconnectorawayfromgasket.
Failure to follow these
instructions could lead to
injury.
20203‐00002
UIC
20130‐00001
locatorpin
chargeport
Finger or
hand hazard.