Segway Personal Transporter i2 - Fender Frame Removal and Installation, x2

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 5‐5
Fender Frame Removal and Installation, x2
To remove fender frame:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Re
movetire/wheelassembly:
• Mod
elx2,page4‐4
• Mod
elx2Turf,page4‐5
3. Re
movefender(page5‐4).
4. Us
inga4mmhexwrench,remove(3)
button‐headframefastenersanddiscard.
Figure5‐3:RemoveorInstallFenderFrame,x2
Fender and fender frame assembly can be
removed as a unit (not shown). If so, frame
fasteners should be discarded and replaced with
new ones.
To install fender frame:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Orientan
dplaceleftandrightfenderframes
onappropriatesideofgearbox.
Gearbox cover must be in place and properly
seated.
3. Usinga4mmhexwrench,drive(3)new
button‐headfasteners(20553‐00002)and
torqueto6N‐m.
4. Installfender(page5‐4).
5. Installtire/w
heelassembly:
• Modelx2
,page4‐4
• Modelx2Turf,page4‐5
6. Pe
rformpost‐servicetests(pageA‐1).
Fender Frame
20959-00001 (left)/20960-00001 (right)
20533-00001