Segway Personal Transporter i2 - Fender Removal and Installation, x2

5‐4 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
Fender Removal and Installation, x2
To remove fender:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Remov
etire/wheelassembly(page4‐4).
3. Usinga4m
mwrench,remove(4)button‐
headfastenerstodetachfenderfromfender
frame.SeeFigure5‐2.
Figure5‐2:RemoveorInstallFender,x2
Fender and frame assembly can be removed as a
unit by removing fender frame fasteners (page
5-5).
To install fender:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Orientan
dplaceleftfenderonleftfender
frame,andrightfenderonrightfender
frame.
3. Ensuregrommet
sareinplaceonfender.If
grommetsneedtobeinstalledusefingerto
pushgrommetintoplace.Notethat
grommetsarebidirectionalandcanbe
installedfromeithersideoffender.
4. Usinga4m
mwrench,drive(4)button‐head
fasteners(20871‐00001)untilseated.Tighten
one‐halftoonefullturn.SeeFigure5‐2.
5. Attachfendertofenderframe(page5‐5).
6. Installt
ire/wheelassembly(page4‐4).
7. Pe
rformpost‐servicetests(pageA‐1).
Fender
20961-00001 (left)/20962-00001 (right)
20871-00001