Segway Personal Transporter i2 - Gearbox Trim Cover Removal and Installation

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 6‐5
Gearbox Trim Cover Removal and Installation
To remove gearbox trim cover:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. (Mo
delx2)Removefenderandframe
assembly(page5‐5)andG‐boxcov
er.
3. (Mo
deli2)Using4mmhexwrench,loosen
andremove(3)button‐headfastenersfrom
gearboxtrimcover.SeeFigure6‐3.
Figure6‐3:RemoveGearboxTrimCover
4. Setasidefastenersandtrimpiece.
To install gearbox trim cover:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Alig
nholesingearboxtrimcoverwithholes
ingearbox.
3. (Modelx2only)In
stallbothfender
(page5‐4)an
dframeassemblies(page5‐5).
4. Th
read(3)button‐headfasteners(20553‐
00001)throughholesingearboxtrimcover
intogearbox.SeeFigure6‐3.
5. Usin
g4mmtorquewrench,drivefasteners
andtorqueto6.0N‐m.
6. Pe
rformpost‐servicetests(pageA‐1).
Gearbox Cover
20152-00002
20553-00001