Segway Personal Transporter i2 - 12. Balance Sensor Assembly

Segway®PersonalTransporteri2,x2,x2TurfPartsReplacementGuide 12‐1
12. Balance Sensor Assembly
Thischapterdescribesremovalandinstallationproceduresfor
thebalancesensorassembly(BSA)onaGen2SegwayPT.
Thefollowingwa
rningsapplytoinstructionsinthisSection12
regardingtheBalanceSensorAssembly:

Failure to do so
could result in
serious injury or
death.
Failure to follow
these instructions
could lead to
electrical shock,
serious injury, death,
or damage to
property.
Failure to follow
these instructions
could lead to
electrical shock,
serious injury, death,
or damage to
property.
Failure to do so
could result in
serious injury or
death or damage to
property.
Read all
instructions.
Power off
the Segway PT.
Unplug the
Segway PT.
Remove
battery packs.
Applies to Models
i2,x2,x2Turf
Qualifications
CertifiedServiceTechnician
Technician Replaceable Parts
BalanceSensorAssembly(19457‐00002)
Fastenersnotincluded
BalanceSensorAssemblyFastener
(20566‐00001)
(4)Fasteners,pan‐head,self‐tapping,
M3
x0.5x12
Required Tools
• T‐10torquewrench
• T‐106‐lobewrench