Segway Personal Transporter i2 - 1. LeanSteer Frame

Segway®PersonalTransporteri2,x2,x2TurfPartsReplacementGuide 1‐1
1. LeanSteer™ Frame
Thischapterdescribesremovalandinstallationproceduresfor
theLeanSteerframeonaGen2SegwayPT.TheLeanSteer
framepivotsatthebasetocontrolleft/rightdirectionofthePT.
Thefollowingwa
rningsapplytotheinstructionsinthis
Section1regardingtheLeanSteerFrame.
Failure to do so
could result in
serious injury or
death.
Failure to follow
these instructions
could lead to
electrical shock,
serious injury, death,
or damage to
property.
Failure to follow
these instructions
could lead to
electrical shock,
serious injury, death,
or damage to
property.
LEANSTEER
• LeanSteer frame must be properly attached and secured.
Failure to properly attach the LeanSteer frame and/or maintain
the torque on the wedge clamp fastener could result in
machine malfunction and could cause personal injury or
damage to the Segway PT. Using the Segway PT without
properly assembling the LeanSteer frame and/or maintaining
the torque on the wedge clamp fastener could lead to an
unexpected change in steering and could result in serious
injury and/or damage to the Segway PT from loss of control,
collisions, and falls.
• Check the tightness of the joint between the LeanSteer frame
and the pivot base assembly routinely and every time the
LeanSteer frame is removed and reinstalled (using the method
outlined in the document).
Read all
instructions.
Power off
the Segway PT.
Unplug the
Segway PT.
Applies to Models
i2,x2,x2Turf
Qualifications
CustomerReplaceable
Customer Replaceable Kits
SeeTableB‐3onpageB‐4.
Technician Replaceable Parts
SeeTableB‐4onpageB‐5.
Required Tools
• Torquewrench
• Hexwrench,3mm
• Hexwrench,5mm