Segway Personal Transporter i2 - Tire;Wheel Assembly Removal and Installation, i2 Only

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 4‐3
Tire/Wheel Assembly Removal and Installation, i2 Only
Support your Segway PT by means other than
resting on its wheels. Support of the unit from
below the batteries is recommended. As an
alternative, the Segway PT can be positioned on
its side.
To remove tire/wheel assembly:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Supportunitortu
rnunitonitsside.
3. Re
movewheelcap.Pressonedgeofwheel
capandliftofffromoppositeedge.(Model
x2Turfhasspa cerasshownonpagexv.)See
Figure4‐1.
4. Us
ing13mmsocketwrench,remove(3)
wheelnuts(20158‐00001).
Figure4‐1:RemoveTire/WheelAssembly,i2
5. Removetire/wheelassembly.
To install tire/wheel assembly:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Placeti
re/wheelassemblyongearbox
flange.SeeFigure4‐1.
3. Usin
g13mmtorquewrench,drive(3)wheel
nuts(20158‐00001)andtorqueto30N‐m.
Tightenonlytotheprescribedtorque.
4. Installwheelcap.
5. Pe
rformpost‐servicetests(pageA‐1).
Tire and Wheel
20162-00003
Wheel Nuts
Wheel Cap
20943-00001
20158-00001