Segway Personal Transporter i2 - CU Board Removal

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 11‐3
CU Board Removal
To remove CU board:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Establishaservicea
blepowerbase(page7‐
1).
3. Re
movepivotbaseassembly(page9‐14).
4. Re
movechassiscover(page10‐3).
5. Disconnect(2)CUmotorh
arnessesfrom
motors(onepermotor).SeeFigure11‐1.
Figure11‐1:DisconnectCUMotorHarnessfromMotor
6. Usesmallflatheadscrewdrivertogentlylift
tabonconnector,andthencarefullypullon
connectortounseat.SeeFigure11‐2.
Figure11‐2:PryConnectorTab
7. Disconnectbalancesensorassemblyharness
andCUharnessfromCUboardby
squeezingplastictabonconnectorand
gentlypullingconnector.SeeFigure11‐3.
8. UseaT‐106‐lobeto
rquewrenchtoremove
14self‐tappingscrewsthatmounttheCU
boardtothechassis.SeeFigure11‐4.
DISCARD FASTENERS AFTER REMOVAL! DO NOT
REUSE!
Figure11‐3:DisconnectHarnessesfromCUBoard
9. GraspCUboardonedgeofheatsinkandlift
fromchassis.SeeFigure11‐4.
Figure11‐4:RemoveCUBoard
connectortab
connectortab
Graspboardbyedgeswhen
removing
CU Board
20945-00001