Segway Personal Transporter i2 - Hub Adapter Removal and Installation, x2;x2 Turf

4‐6 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
Hub Adapter Removal and Installation, x2/x2 Turf
To remove hub adapter:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Remov
etire/wheelassembly:
• Modelx2
,page4‐4
• Modelx2Tu
rf,page4‐5
NOTE: Thisstepisnotrequiredifyouare
removingentirewheelassemblyfrom
gearbox.
Figure4‐4:RemoveorInstallHubAdapter,x2
3. Using13mmhexwrench,remove(3)
fastenersattachinghubadaptertowheel.
4. Liftoffhubada
pter.
To install hub adapter:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Inspectmoun
tingsurface;usealcoholwipes
tocleanoffalldebris.
3. Al
ignthreecenterholesinhubadapteror
entirewheelassemblywithlugsongearbox.
Seathubadapteroverlugsagainstgearbox
flange.SeeFigure4‐4.
4. Thread(3)13
mmwheelnuts(20158‐00001)
throughholesinhubadapterontolugs.
5. Using13
mmtorquewrench,tightento
30N‐m.
Tightenonlytoth
eprescribedtorque.
6. Pe
rformpost‐servicetests(pageA‐1).
Hub Adapter
20963-00001
20158-00001