Segway Personal Transporter i2 - Handlebar Removal and Installation

1‐4 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
Handlebar Removal and Installation
To remove handlebar from LeanSteer frame:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Use3mmhe
xwrenchtoremove(3)
fasteners.SeeFigure1‐2.
Figure1‐2:InstallingandRemovingHandlebar
3. Removehandlebarandhandlebarclamp
fromLeanSteerframe.
To install handlebar on LeanSteer frame:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Pla
cehandlebaragainstLeanSteerframe
withthebevelfacingbackwardandSegway
logofacingup.SeeFigure1‐2.
3. Po
sitionhandlebarclampagainsthandlebar.
4. Insert(3)fasteners(20
306‐00001)through
handlebarclampintoLeanSteerframeand
tightenbyhand.
5. Checktoensureth
atgapbetweenhandlebar
clampandLeanSteerframeisevenand
equidistantbetweentopandbottom.
6. Using3m
mhexwrench,alternatebetween3
fasteners,evenlytighteninginsmall
incrementsuntilfulltorquesettingof6.0N‐
misachieved.
7. Pe
rformpost‐servicetests(pageA‐1).
HandlebarClamp
Handlebar
20955‐00001
20046‐00001Black
20306‐00001
20046‐00002White
20046‐00004Sage
20046‐00005Silver