Segway Personal Transporter i2 - Tire;Wheel Assembly Removal and Installation, x2 Turf only

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 4‐5
Tire/Wheel Assembly Removal and Installation, x2 Turf only
To remove tire/wheel assembly:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Supportunitortu
rnunitonitsside.
3. Ifremovingtire
/wheelassemblyandhub
adapter,proceedtopage4‐6.
4. Us
e8mmhexwrenchtoremove(4)8mm
fasteners.SeeFigure4‐3.
Figure4‐3:RemoveorInstallTire/WheelAssembly,x2Turf
5. Liftoffwheeltrim.
6. Loosentire/
wheelassemblybytappingside
ofwheelwithplasticorrubbermallet.
7. Liftoffti
re/wheelassembly,including
spacer.SeeFigure4‐3.
To install tire/wheel assembly:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Inspectwheelmou
ntingsurfaces;use
alcoholwipestocleanoffalldebris.
3. Placespa
ceroverhubadapter;align
mountingholes.SeeFigure4‐3.
4. Placewh
eeloverhubadapterwithvalve
stemfacingoutward;alignmountingholes.
5. Placewh
eeltrimonwheel;alignmounting
holes.
6. Th
read(4)8mmfasteners(includedwith
kit)throughtrimandwheelandintohub
adapter.
7. Wh
ileholdingtiretokeepfromrotating, use
8mmtorquewrenchtotightento30N‐m.
Tightenonlytotheprescribedtorque.
8. Pe
rformpost‐servicetests(pageA‐1).
TireandWheel
20816‐00001
Wheel Trim
20965‐00001
20991‐00002
Spacer
21370‐00001