Segway Personal Transporter i2 - Mat Removal and Installation

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 2‐3
Mat Removal and Installation
To remove mat:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Liftma
toffpowerbase.SeeFigure2‐1.
Figure2‐1:RemoveorInstallMats
To install mat:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Ve
rifythattopofpowerbaseandbottomof
matareclean,dry,andfreeofdebris.
3. Placema
tonpowerbase.
4. Fitma
t’srubbertabsintoslotsformedby
gapbetweenfrontandrearfasciaandpower
base.SeeFigure2‐1.
5. Tu
cktabsinplacearoundentireperimeter
ofmatwhileyoupress down.
6. Vi
suallyconfirmthatmatisproperly
alignedandallrubbertabsaretuckedin
priortoriding.
7. Pe
rformpost‐servicetests(pageA‐1).
fronttabs
reartabs