Segway Personal Transporter i2 - Before Removing Fascias

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 6‐3
Before Removing Fascias
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Re
moveonetire/wheelassembly:
• Mod
eli2,page4‐3
• Mod
elx2,page4‐4
• Mod
elx2Turf,page4‐5
3. Becauseofint
erferenceonthei2andx2,you
mustremovethefollowing:
• (Mo
deli2only)Removeonefender
(page5‐3).
• (Mo
delx2only)Removebothfenders
(page5‐4)an
dfenderframesasaunit
(page5‐5).
AllPTmodelsha
vebeenmanufacturedwith
oneoftworevisionsoftheconsolehousingand
trim.Therevisionisdeterminedbythepart
numberoftheconsoletrim,whichislocatedon
theforwardpartofthehousingandisvisible
afterthecoverisremoved.Thepartnumbersfor
eachre
visionoftheconsoletrimareasfollows:
• FirstRevi
sion:20951‐00001(Black)or20951‐
00002(White)
• SecondRevision:212
81‐00001(Black)or
21281‐00002(White)
First-revision console housing cover parts are no
longer manufactured or supported. First-revision
components are not compatible with second-
revision components; similarly, second-revision
components are not backward compatible with
first-revision components. AS A RESULT, IF ANY
FIRST-REVISION CONSOLE HOUSING, GASKET,
OR COVER IS DAMAGED, THE COVER, GASKET,
HOUSING, AND TRIM MUST ALL BE REPLACED
USING THE CURRENT (SECOND) REVISION.