Segway Personal Transporter i2 - Disassembling and Reassembling Chassis Components

14‐4 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
Disassembling and Reassembling Chassis Components
To disassemble chassis components:
Removecomponentsfromdamagedchassisby
followingproceduresforindividualSegwayPT
components:
1. MakesureSegw
ayPTispoweredoffand
unplugged.
2. Establishaserv
iceablepowerbase
(page7‐1).
3. Remov
egearbox(qty2)(page8‐4).
4. Remov
epivotbaseassembly(page9‐14).
5. Remov
echassiscover(page10‐3).
6. Remov
eCUboard(qty2)(page11‐3).
7. Remov
ebalancesensorassembly
(page12‐3).
8. Remov
emotor(qty2)(page13‐3).
To reassemble chassis components:
Installcomponentsontoreplacementchassisby
followingproceduresforindividualSegwayPT
components:
1. MakesureSegw
ayPTispoweredoffand
unplugged.
2. Installmotor(qty2)(page13‐4).
3. Installbal
ancesensorassembly
(page12‐3).Us
eself‐tappingfasteners.
4. InstallCUboa
rd(qty2)(page11‐5).Useself‐
tappingfa
steners.
5. Installchassi
scover(page10‐3).
6. Installpiv
otbaseassembly(page9‐15).
7. Installge
arbox(qty2)(page8‐5).