Segway Personal Transporter i2 - Page 85

Segway®PersonalTransporteri2,x2,x2Turf PartsReplacementGuide 9‐15
To install pivot base assembly:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Installconsol
ehousing(page9‐16).
3. Wi
thpivotbaseangledstraightup,guide(4)
harnessconnectorsthroughbottomofbase
plate.SeeFigure9‐17.
4. Th
read(2)SHCS,M6x1x20,6‐lobescrews
(20205‐00001)throughbaseplateandchassis
coverintochassis.
5. Inspecth
arnessestoensureproper
alignment.
6. Us
ingT‐306‐lobewrench,driveeachscrew
andtorqueto11.0N‐m.
7. InstallEM
Ifilter(page9‐13).
8. An
yPTwithoutferritecoresmustbe
retrofittedwithferritesuponreassembly.
Onesmallferritecore(21270‐00001)is
placedoneachBSAharnessbetweenchassis
coverandEMIfilter.Onelargeferritecore
(21271‐00001)isplacedonBsideCUharness
(10‐pinconnector)underUIC.
Ferrite cores can physically impede installation of
new UIC. Take special care to correctly place
ferrite cores and route cables to avoid damage
when installing UIC.
9. InstallUIC(page9‐10).
10. Installconsol
ecover(page9‐5).
11. Pe
rformpost‐servicetests(pageA‐1).