Segway Personal Transporter i2 - Tire;Wheel Assembly Removal and Installation, x2 only

4‐4 Segway®PersonalTransporteri2,x2,x2TurfPartsReplacement
Tire/Wheel Assembly Removal and Installation, x2 only
To remove tire/wheel assembly:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Supportun
itorturnunitonitsside.
3. Ifre
movingtire/wheelassemblyandhub
adapter,proceedtopage4‐6.
4. Use8mmhe
xwrenchtoremove(4)
fasteners.SeeFigure4‐2.
Figure4‐2:RemoveorInstallTire/WheelAssembly,x2
5. Liftoffwheeltrim.
6. Loosentire
/wheelassemblybytappingside
ofwheelwithplasticorrubbermallet.
7. Liftofftire/w
heelassembly.
To install tire/wheel assembly:
1. MakesureSegwayPTispoweredoffand
unplugged.
2. Inspectwhe
elmountingsurfaces;use
alcoholwipestocleanoffalldebris.
3. Pla
cewheeloverhubadapterwithvalve
stemfacingoutward;alignmountingholes.
4. Pla
cewheeltrimonwheel;alignmounting
holes.SeeFigure4‐2.
5. Thread(4)8mmfasteners(2
0991‐00001)
throughtrimandwheelandintohub
adapter.
6. Whileholdi
ngtiretokeepfromrotating,use
8mmtorquewrenchtotightento30N‐m.
Tightenonlytoth
eprescribedtorque.
7. Pe
rformpost‐servicetests(pageA‐1).
TireandWheel
18357-00002
Wheel Trim
20965-00001
20991-00001