Shinko PCB1 - Page 41

- 41 -
Wait parameter
Wait value
setting
RUN mode
//25
1 ////
RUN mode
Program control STOP (in Standby)
wait
1 ///0
Wait parameter setting mode
Wait value
+ key (3 sec)
wait
1 //10
10
or
key
MODE key
wait
1 ----
PTN/STEP
p.
Step 1
Wait function Enabled/Disabled
wait
1 use/
PTN/STEP
p.
Wait function Enabled
or
key
MODE key
Repeat settings up to ‘Step 5 wait
function Enabled/Disabled’.
wait
1 use/
PTN/STEP
p.
Step 5
Wait function Enabled/Disabled
Wait function Enabled
RUN mode
//25
1 ////
RUN mode
Program control STOP (in Standby)
RST key
At this stage, settings are complete.
PTN key