Shinko PCB1 - Page 66

- 66 -
Characters,
Factory Default
Setting Item, Function, Setting Range
wact
1 ----
PTN/STEP
indicator 7
lights up.
Step 7 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 7, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
wact
1 ----
PTN/STEP
indicator 8
lights up.
Step 8 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 8, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
wact
1 ----
PTN/STEP
indicator 9
lights up.
Step 9 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 9, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
wact
1 ----
PTN/STEP
indicator 10
lights up.
Step 10 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 10, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
At this stage, settings for Wait parameter setting mode are complete.
Press the RST key. The unit reverts to RUN mode.