Shinko PCB1 - Page 65

- 65 -
Characters,
Factory Default
Setting Item, Function, Setting Range
wact
1 ----
PTN/STEP
indicator 1
lights up.
Step 1 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 1, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
wact
1 ----
PTN/STEP
indicator 2
lights up.
Step 2 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 2, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
wact
1 ----
PTN/STEP
indicator 3
lights up.
Step 3 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 3, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
wact
1 ----
PTN/STEP
indicator 4
lights up.
Step 4 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 4, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
wact
1 ----
PTN/STEP
indicator 5
lights up.
Step 5 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 5, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.
wact
1 ----
PTN/STEP
indicator 6
lights up.
Step 6 wait function Enabled/Disabled
• Selects the wait function Enabled or Disabled at Step 6, based on the wait
value set in [Wait value].
• Selection item:
---- Disabled
use/ Enabled
Not available if wait value is set to 0 or 0.0.