ONLINE HELP SOPAS Chapter 5
LECTOR®620
Parameters
8013778/Y269/2013-11-27 © SICK AG · Germany · All rights reserved · Subject to change without notice 81
5.8.5.1.2 Or teach-in via function buttons
If the Or teach-in via function buttons parameter is activated, the matchcode can also be
taught in via the buttons on the LECTOR
®
620. No signal is required in order to prepare
teach-in (Activating teach-in mode).
5.8.5.1.3 Teach-in stop by
Depending on the setting for the Start teach-in parameter, the Teach-in stop by parameter
is used to define which signal or condition stops teach-in of the matchcode.
• T
EACH-IN TRIGGER SOURCE: Teach-in is stopped by a signal (e.g. a key switch) at one of the
digital inputs of the LECTOR
®
620.
• O
BJECT TRIGGER: Teach-in stops as soon as the reading gate is closed.
• T
AUGHT VALID CODE: Teach-in stops as soon as a matchcode was read successfully.
5.8.5.1.4 Teach-in condition
The Teach-in condition parameter defines the condition in which the newly taught-in match
code content is stored. The selected condition is used as a basis when activating the target/
actual comparison. Each code that is read is compared to the read-in code content for the
target condition.
The code contents to be compared are assigned to a condition via the Teach-in condition
parameter. The taught-in match codes can be started and activated at a later time, subject
to the condition.
5.8.5.1.5 Inverting a condition
A condition can be inverted using the Inverting a condition parameter. Inverting a condition
allows all code contents to be approved except the taught-in match code content.
With this function, it is possible to prevent a particular product from leaving the production
line.
5.8.5.1.6 Teach-in code content
If the Teach-in code content parameter is activated, the code content of the matchcode is
taught in and included as a condition.
This reduces the likelihood of the code being confused with other codes.
5.8.5.1.7 Teach-in code ID (type)
If the Teach-in code ID (type) parameter is activated, the code type of the matchcode is
taught in.
This reduces the likelihood of the code being confused with other codes.
To Next Page
Loading...
Need help?
General