SICK M4000 Advanced

Operating Instructions
M4000 Adv., Adv. A/P, Area
4 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 8010797/YT72/2016-02-19
Subject to change without notice
Contents
4.2.5 Muting with four sensors (two sensor pairs), serial
placement ......................................................................................... 34
4.2.6 Muting with four sensors (two sensor pairs), parallel
placement ......................................................................................... 36
5 Configurable functions................................................................................................... 38
5.1 Restart interlock ................................................................................................. 38
5.2 Beam coding ....................................................................................................... 40
5.3 Application diagnostic output (ADO).................................................................. 41
5.4 Scanning range...................................................................................................42
5.4.1 Scanning range of the M4000 Advanced ....................................... 43
5.4.2 Scanning range of the M4000 Advanced Curtain system ............. 43
5.4.3 Scanning range of the M4000 Advanced A/P ................................ 44
5.4.4 Scanning range of the M4000 Area 60/80.................................... 45
5.5 External device monitoring (EDM) ..................................................................... 46
5.6 Sender test.......................................................................................................... 47
6 Configurable muting functions......................................................................................48
6.1 Number of muting sensors ................................................................................ 48
6.2 Sensor test.......................................................................................................... 50
6.2.1 Testable sensors...............................................................................50
6.2.2 Non-testable sensors ....................................................................... 50
6.3 Time monitoring..................................................................................................51
6.3.1 Concurrence monitoring................................................................... 51
6.3.2 Monitoring of the total muting time................................................. 51
6.3.3 Sensor gap monitoring ..................................................................... 52
6.3.4 Belt stop ............................................................................................52
6.3.5 End of muting by ESPE ..................................................................... 53
6.3.6 Exit monitoring .................................................................................. 53
6.4 Direction detection ............................................................................................. 55
6.5 Sequence monitoring ......................................................................................... 55
6.6 Partial blanking...................................................................................................56
6.7 Partial blanking/muting changeover ................................................................. 57
6.8 Override............................................................................................................... 59
6.8.1 Override realised using an external circuit...................................... 59
6.8.2 Override realised with the integrated override function................. 60
6.9 Monitoring the muting lamp...............................................................................62
6.10 Combinable muting functions and facilities for connecting............................. 63
7 Mounting.......................................................................................................................... 64
7.1 Determining the minimum distance.................................................................. 64
7.1.1 Minimum distance to the hazardous area ...................................... 65
7.1.2 Minimum distance to reflective surfaces........................................68
7.2 Steps for mounting the device...........................................................................69
7.2.1 Mounting with Omega bracket......................................................... 71
7.2.2 Mounting with swivel mount bracket............................................... 72
7.2.3 Mounting with side bracket..............................................................74
7.2.4 Mounting with rigid mounting bracket ............................................ 76
7.2.5 Mounting with pivoting mounting bracket.......................................78