SICK Master Data Analyzer

APPENDIX 11
121
8020065-ZLP4/2017-08-10|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | Master Data Analyzer
11.2 List of figures
Fig. 1: Protective devices ............................................................................................... 17
Fig. 2: Work station ........................................................................................................ 18
Fig. 3: System components ........................................................................................... 21
Fig. 4: Hand-held scanner .............................................................................................. 21
Fig. 5: Electronic scales ................................................................................................. 22
Fig. 6: MLG-2 light grids ................................................................................................. 22
Fig. 7: Measurement gantry with light grids ................................................................. 23
Fig. 8: Wire draw encoder .............................................................................................. 23
Fig. 9: Controller MSC800 ............................................................................................. 24
Fig. 10: Display ................................................................................................................. 24
Fig. 11: IP camera (MDA650 Image/MDA800 Image only) ........................................... 24
Fig. 12: Housing ................................................................................................................ 25
Fig. 13: WLAN module ...................................................................................................... 25
Fig. 14: Measurement process for each operating mode .............................................. 26
Fig. 15: Marked measurement field on the glass panel ................................................ 27
Fig. 16: Operating principle – bar code reading ............................................................. 27
Fig. 17: Operating principle – volume measurement ..................................................... 28
Fig. 18: Operating principle – Weighing process ............................................................ 29
Fig. 19: Operating principle – Visualization of measurement results ........................... 30
Fig. 20: Status indicators – Light grids ........................................................................... 32
Fig. 21: Status indicators – Hand-held scanner ............................................................. 33
Fig. 22: Status indicators – IP camera ............................................................................ 34
Fig. 23: Status indicators – Display................................................................................. 34
Fig. 24: Status indicators – WLAN module ..................................................................... 35
Fig. 25: Transporting with a lifting device ....................................................................... 38
Fig. 26: Lifting the MDA from the transport pallet .......................................................... 40
Fig. 27: Risk of crushing when settings down the MDA ................................................. 41
Fig. 28: Removing the transport locks on the electronic scales .................................... 43
Fig. 29: Mounting the WLAN module .............................................................................. 44
Fig. 30: Hand-held scanner connected as standard ...................................................... 46
Fig. 31: Connections on the controller housing .............................................................. 46
Fig. 32: Connecting the MDA to the voltage supply ....................................................... 47
Fig. 33: Connecting the MDA to the Ethernet ................................................................. 48
Fig. 34: Connecting the WLAN adapter ........................................................................... 49
Fig. 35: Checking whether objects are detected ............................................................ 51
Fig. 36: Connection with the configuration PC ............................................................... 52
Fig. 37: Service and data interface ................................................................................. 52
Fig. 38: Loading device drivers into the SOPAS project ................................................. 57
Fig. 39: Loading standard parameters into the SOPAS project ..................................... 59
Fig. 40: Integration of the IP camera ............................................................................... 66
Fig. 41: Connecting the configuration PC to the WLAN module .................................... 67