3 SYSTEM DESCRIPTION
8020065-ZSP4/2017-08-10|SICK
OPERATING INSTRUCTIONS | Master Data Analyzer
Subject to change without notice
3.5.3 Status indicators – IP camera
The IP camera mounted to the measurement gantry for the MDS650/800 is equipped
with a status LED.
Fig. 22: Status indicators – IP camera
LED is off
Connection and normal operation
Permanently green for 10 seconds for normal operation following system
start
Permanently on during start-up.
Flashes during firmware update.
Flashes yellow/red if the network connection is not available or has been
lost.
Tab. 9: Status indicators – IP camera
3.5.4 Status indicators – Display
The display is used to visualize the measurement results as well as for interacting with the
system to troubleshoot error messages.
The screen is controlled by gently touching the respective touch pads. The touch pads on
the touch screen vary according to the operational context.
Fig. 23: Status indicators – Display
Notes on the correct use of the touch screen
You are only permitted to touch the touch screen with your fingers. Gently press the touch
pads to operate them; do not apply force.
Do not operate the touch screen with pointed or sharp objects; otherwise, the surface of
the touch screen will become damaged.
To Next Page
Loading...
