SYSTEM DESCRIPTION 3
8020065-ZLP4/2017-08-10|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | Master Data Analyzer
3.2 System components
The Master Data Analyzer consists of:
1. One hand-held scanner for scanning bar code information (only in the operating mode
with bar code scanning).
2. One set of rugged electronic scales with a glass panel for supporting the measuring
object.
3. One moving measurement gantry with two pairs of light grids for recording the
object’s dimensions and a wire draw encoder for calculating the length.
4. One controller for recording the measurement data and emitting the measurement
results to the customer’s system.
5. One display for visualizing the measurement results.
6. One IP camera (only for MDA650 Image/MDA800 Image).
7. One stable mechanism for holding the components
8. One WLAN module available as an accessory for mobile applications of the MDA.
Fig. 3: System components
1 – Hand-held scanner
In the operating mode with bar code scanning, the number used to identify the object is
detected using a wired hand-held scanner. The IDM26x hand-held scanner recognizes 1D
and 2D bar codes and all common stacked codes.
Fig. 4: Hand-held scanner
The hand-held scanner is connected to the MDA’s controller by a cable. This cable is used
to both supply the hand-held scanner with voltage and transmit data.
To Next Page
Loading...
