OPERATION 7
8020065-ZLP4/2017-08-10|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | Master Data Analyzer
7.3.3.2 Checking measurements with the 2D display
Depending on the current settings, the object is shown in a 2D display from above (top
view) or from the side (side view).
▸
You can switch between the two 2D displays. To do so, press the symbols to the right of
the measurement field.
The top view also visualizes the smallest enveloping cuboid (the box volume).
7.3.3.3 Displaying the measuring object in a live view
If the MDA650 Image / MDA 800 Image system variant is in use, the symbol for the live
display appears on the right, next to the graphic display.
▸
Press the symbol.
The graphic display shows an image of the current measuring situation.
The image is updated with each new measurement.
Note
Note
To Next Page
Loading...
Need help?
General
