SICK Master Data Analyzer

COMMISSIONING 6
67
8020065-ZLP4/2017-08-10|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | Master Data Analyzer
6.8 Configuring the WLAN module
Commission the WLAN module according to the operating instructions included with the
delivery from the manufacturer of the device.
To configure the WLAN module, a graphical user interface is available which is accessible
via a web browser.
Connecting the configuration PC to the WLAN module
Establish a direct connection between the WLAN module and the configuration PC.
Fig. 41: Connecting the configuration PC to the WLAN module
1. To do this, unplug the RJ45 male connector on the WLAN module from the Data
connection.
2. Plug the male connector into the configuration PC’s network socket.
3. Follow the instructions given in the operating instructions supplied by the device
manufacturer.
Testing the configuration
▸
Reconnect the WLAN module to the Master Data Analyzer following device
configuration.