SICK nanoScan3

2 Safety information
2.1 General safety notes
Product integration
DANGER
T
he product can not offer the expected protection if it is integrated incorrectly.
►
Plan the integration of the product in accordance with the machine requirements
(project planning).
►
Implement the integration of the product in accordance with the project planning.
Laser class 1
CAUTION
If an
y operating or adjusting devices other than those specified in this document are
used or other methods are employed, this can lead to dangerous exposure to radiation.
►
Only use the operating or adjusting devices specified in this document.
►
Only follow the methods specified in this document.
►
Do not open the housing, except for the purposes of the installation and mainte‐
nance work specified in these operating instructions.
LASER
1
Figure 1: Laser class 1
T
his device complies with the following standards:
•
IEC60825-1:2014
•
21CFR1040.10 and 1040.11, except compliance with IEC60825-1:2014, as
described in Laser Notice No.56 dated 08.05.2019
The laser is eye-safe.
The laser marking is located on the underside of the safety laser scanner.
Mounting and electrical installation
DANGER
D
eath or severe injury due to electrical voltage and/or an unexpected startup of the
machine
►
Make sure that the machine is (and remains) disconnected from the voltage
supply during mounting and electrical installation.
►
Make sure that the dangerous state of the machine is and remains switched off.
2 SAFETY INFORMATION
10
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 – EtherNet/IP™ 8027909/2023-02-22 | SICK
Subject to change without notice