SICK nanoScan3

•
P
art number:
•
Hardware version:
Connection
•
C
onnection status:
•
Type:
Checksums
A c
hecksum is used as a unique identification for a configuration. Using the checksum,
it is possible to work out whether a setup was changed or whether two devices have the
same configuration.
The checksum of the configuration in the project may not match the checksum in the
device, for example if a field geometry has been modified, but not yet transmitted to the
device.
System status
•
Applic
ation status:
•
Last message:
•
Device configuration date:
•
Synchronization:
Shows whether the configuration in Safety Designer and the configuration in the
de
vice are identical.
•
V
erification state project:
•
Verification state device:
Time synchronization
•
C
onfigured value in the project
•
Configured values in the device
Measured data
S
hows the measurement data when a device is connected.
Indicator
S
hows the status of the display and LEDs when a device is connected.
Establishing connection
If t
he safety laser scanner is correctly connected, you can establish the connection to
the safety laser scanner by clicking Connect.
7.4 Network settings
7.4.1 EtherNet/IP
IP address:
If y
ou want to address the device via TCP/IP or output data, make the IP settings here.
Reading and transmitting values
If t
he values in the project and the values in the device differ, you can read the values
out from the device and adopt them in the project. Alternatively, you can transmit
values from the project to the device.
7 C
ONFIGURATION
66
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 – EtherNet/IP™ 8027909/2023-02-22 | SICK
Subject to change without notice