You can adjust the settings in the Safety Designer main window.
T
able 27: Data recorder
Start recording
Stop recording
Prerequisites
•
Exis
ting connection between Safety Designer and device
•
Configuration in the project and configuration in the device are synchronized.
Typical applications
•
Chec
k spatial geometry
•
Check where a person can stay or when a person is detected
•
Check input information about the current monitoring case
•
Check why safety outputs have switched
11.4.2 Event history
Overview
Figure 48: Event history
1
Data source
2
Available views
3
Navigation
11 TROUBLESHOOTING
112
O P E R A T I N G I N S T R U C T I O N S | nanoScan3 – EtherNet/IP™ 8027909/2023-02-22 | SICK
Subject to change without notice
To Next Page
