SICK nanoScan3

8 Commissioning
8.1 Safety
Important information
WARNING
D
angerous state of the machine
The machine or the protective measure may not yet behave as you have planned
When changes are made to the machine, the effectiveness of the protective measure
may be affected unintentionally.
►
Before commissioning the machine, make sure that the machine is first checked
and released by qualified safety personnel.
►
Only operate the machine with a perfectly functioning protective device.
►
Check the effectiveness of the protective measure after each change to the
machine, the integration or the operating and boundary conditions of the safety
laser scanner. Perform commissioning again.
8.2 Overview
Prerequisites
•
Pr
oject planning has been completed.
•
Mounting is complete.
•
Electrical installation is completed.
•
Configuration is completed.
•
No-one is in the hazardous area during commissioning.
Further topics
•
"Pr
oject planning", page 19
•
"Mounting", page 55
•
"Electrical installation", page 57
•
"Configuration", page 59
8.3 Alignment
Overview
V
arious options are available for precisely aligning the safety laser scanner depending
on the mounting kit that is used.
Approach
1.
Align the safety laser scanner.
2. Tighten the screws to the specified tightening torque.
3. Check alignment.
8.4 Switching on
After switching on, the safety laser scanner performs various internal tests. The OFF
LED illumina
tes continually. The ON LED is off.
When the start procedure is complete, the status LEDs and the display show the safety
laser scanner’s current operational status.
COMMISSIONING 8
8027909/2023-02-22 | SICK O P E R A T I N G I N S T R U C T I O N S | nanoScan3 – EtherNet/IP™
95
Subject to change without notice