Siemens Brodersen MC55 AT - ATS8 Set Number of Seconds to Wait for Comma Dialing Modifier

MC55_ATC_V04.00 Page 141 of 475 3/17/06
Confidential / Released
7.14 ATS8 Set number of seconds to wait for comma dialing modifier
This command specifies the amount of time, in seconds, that the DCE shall pause, during signalling of call
addressing information to the network (dialling), when a "," (comma) dial modifier is encountered in a dial string.
Syntax
Command Description
No effect for GSM.
Parameter Description
0
(&F)
DCE does not pause when "," encountered in dial string
1...255 Number of seconds to pause
Read Command
ATS8?
Response(s)
<n>
OK
Write Command
ATS8=<n>
Response(s)
OK
ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
V.250 ! % ! % ! ! ! ! !
<n>
(num)(&W)(&V)