Siemens Brodersen MC55 AT - AT^SNFPT Set Progress Tones

MC55_ATC_V04.00 Page 417 of 475 3/17/06
Confidential / Released
17.14 AT^SNFPT Set progress tones
AT^SNFPT controls the Call Progress Tones generated at the beginning of a mobile originated call setup.
Please note that the setting is stored volatile, i.e. after restart or reset, the default value 1 will be restored.
Syntax
Parameter Description
0 Disables Call Progress Tones
1
(P)
Enables Call Progress Tones (audible tones shortly heard on the phone when
ME starts to set up a call.)
Test Command
AT^SNFPT=?
Response(s)
^SNFPT: (list of supported <pt>s)
OK
Read Command
AT^SNFPT?
Response(s)
^SNFPT: <pt>
OK
Write Command
AT^SNFPT=<pt>
Response(s)
OK
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
SIEMENS ! % % % % % ! ! !
<pt>
(num)