Siemens Brodersen MC55 AT User Manual

MC55_ATC_V04.00 Page 327 of 475 3/17/06
Confidential / Released
12.25 AT+FTH Transmit Data Using HDLC Framing
The AT+FTH command causes the TA to transmit data using the HDLC protocol and the modulation schemes
defined in Section 12.1, FAX parameters. An ERROR response code results if the command is issued while the
modem is on-hook. The test command can be used in off-hook mode to check the modulation schemes sup-
ported by MC55.
Syntax
Note
• Used for Fax Class 1 only
Test Command
AT+FTH=?
Response(s)
In off-hook mode only:
+FTH:(list of <mod>s)
OK
In on-hook mode:
ERROR
Write Command
AT+FTH=<mod>
Response(s)
CONNECT
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
TIA/EIA-578 ! % ! % ! ! ! ! !

Siemens Brodersen MC55 AT Specifications

General

Brand	Siemens
Model	Brodersen MC55 AT
Category	Modem
Language	English