Siemens Brodersen MC55 AT - AT+FBOR Query Data Bit Order

MC55_ATC_V04.00 Page 306 of 475 3/17/06
Confidential / Released
12.4 AT+FBOR Query data Bit Order
This command queries the bit order for the receive mode. The mode is set by the ME depending on the selected
Service Class, see "AT+FCLASS Fax: Select, read or test service class".
Syntax
Parameter Description
bit order modes
0 Direct bit order for both Phase C and for Phase B/D data.
[1] Reversed bit order for Phase C data, direct Bit Order for Phase B/D data.
Note
• Used for Fax Class 2 only.
Test Command
AT+FBOR=?
Response(s)
(list of supported <bor>s)
OK
Read Command
AT+FBOR?
Response(s)
<bor>
OK
Write Command
AT+FBOR=<bor>
Response(s)
OK
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
EIA PN-2388 ! % ! % ! ! ! ! !
<bor>
(num)