Siemens Brodersen MC55 AT - AT+CLIR Calling Line Identification Restriction

MC55_ATC_V04.00 Page 210 of 475 3/17/06
Confidential / Released
9.10 AT+CLIR Calling line identification restriction
The AT+CLIR command refers to the GSM supplementary service CLIR (Calling Line Identification Restriction).
Syntax
Parameter Description
Parameter shows the settings for outgoing calls:
[0]
(P)
Presentation indicator is used according to the subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
Parameter shows the subscriber CLIR service status in the network:
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 Unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
Note
• The settings made with AT+CLIR=1 or AT+CLIR=2 are used for all outgoing calls until the ME is switched off
or AT+CLIR=0 is used.
Test Command
AT+CLIR=?
Response(s)
+CLIR: (list of supported <n>s)
OK
Read Command
AT+CLIR?
Response(s)
+CLIR<n>, <m>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CLIR=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
GSM 07.07 % % % % % % ! ! !
<n>
(num)
<m>
(num)