Siemens Brodersen MC55 AT - Using the GPRS Dial Command ATD

MC55_ATC_V04.00 Page 300 of 475 3/17/06
Confidential / Released
11.21 Using the GPRS dial command ATD
Example
In addition to the GPRS AT commands you can use the "D" command to dial into to the GPRS network.
There are two GPRS Service Codes for the ATD command: Values 98 and 99.
Examples:
ATD*99#
CONNECT Establish a connection by service code 99.
ATD*99*123.124.125.126*PPP*1#
CONNECT Establish a connection by service code 99, IP
address 123 and L2P = PPP and using CID 1.
The CID has to be defined by AT+CGDCONT.
ATD*99**PPP#
CONNECT Establish a connection by service code 99 and L2P
= PPP.
ATD*99***1#
CONNECT Establish a connection by service code 99 and using
CID 1.
ATD*99**PPP*1#
CONNECT Establish a connection by service code 99 and L2P
= PPP and using CID 1. The CID has to be defined
by AT+CGDCONT.
ATD*98#
CONNECT Establish a connection by service code 98.
ATD*98*1#
CONNECT Establish an IP connection by service code 98 using
CID 1. The CID has to be defined by AT+CGDCONT.