Siemens Brodersen MC55 AT - 11.7 AT+CGDCONT Define PDP Context

MC55_ATC_V04.00 Page 277 of 475 3/17/06
Confidential / Released
11.7 AT+CGDCONT Define PDP Context
Syntax
Command Description
The test command returns supported values as a compound value.
The read command returns the current settings for each defined PDP context.
The write command specifies the parameters for a PDP context identified by the context identifier <cid>. The
number of contexts that may be in a defined state at the same time is given by the range returned by the test
command. A special form of the write command (AT+CGDCONT=<cid>) causes the values for context <cid> to
become undefined.
Parameter Description
PDP Context Identifier
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Packet Data Protocol type
Specifies the type of the packet data protocol.
"IP" Internet Protocol (IETF STD 5)
Test Command
AT+CGDCONT=?
Response(s)
+CGDCONT: (range of supported<cid>s), <PDP_type>, , , (list of supported <d_comp>s), (list of supported
<h_comp>s)
OK
ERROR
+CME ERROR
Read Command
AT+CGDCONT?
Response(s)
[+CGDCONT: <cid>, <PDP_type>, <APN>, <PDP_addr>, <d_comp>, <h_comp>]
[+CGDCONT: ...]
OK
ERROR
+CME ERROR
Write Command
AT+CGDCONT=[<cid>[, <PDP_type>[, <APN>[, <PDP_addr>]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
GSM 07.07 % % % % % % ! ! !
<cid>
(num)
<PDP_type>
(str)