Siemens Brodersen MC55 AT User Manual

MC55_ATC_V04.00 Page 422 of 475 3/17/06
Confidential / Released
17.17 AT^SNFV Set loudspeaker volume
AT^SNFV can be used to set the volume of the loudspeaker to the value <outCalibrate> addressed by <out-
Step>. The read and write commands refer to the active audio mode. The write command works only in audio
modes 2 to 6.
Syntax
Parameter Description
The actual volume of each step is defined by the parameter <outCalibrate>, which can be set with AT^SNFO.
0...4
(P)
Notes
• Any change to <outStep> takes effect in audio modes 2 to 6. That is, when you change <outStep> and
then select another mode with AT^SNFS, the same step will be applied. Nevertheless, the actual volume can
be quite different, depending on the values of <outCalibrate> set in each mode. The only exception is
audio mode 1 which is fixed to <outStep>=4.
• <outStep> is stored non-volatile when the ME is powered down with AT^SMSO or reset with AT+CFUN=1,1.
<outStep> is not stored by AT^SNFW.
• <outStep> can also be changed by AT^SNFO (Section 17.13) and AT+CLVL (Section 17.4).
Test Command
AT^SNFV=?
Response(s)
^SNFV: (list of supported <outStep>s)
OK
Read Command
AT^SNFV?
Response(s)
^SNFV: <outStep>
OK
Write Command
AT^SNFV=<outStep>
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
SIEMENS ! % % % % % ! ! !
<outStep>
(num)

Siemens Brodersen MC55 AT Specifications

General

Brand	Siemens
Model	Brodersen MC55 AT
Category	Modem
Language	English