MC55_ATC_V04.00 Page 183 of 475 3/17/06
Confidential / Released
Note
• For compatibility with earlier products and to support legacy applications, often any input character will stop
the periodic output of the write command. But since this applies only in certain cases (depending on the set-
tings of AT+IPR and AT+CMUX), it is recommended to always use "at" or "AT".
8.10.1 AT^SMONG Cell Info Table
Example output for AT^SMONG:
Columns of the cell info table:
GPRS Monitor
BCCH G PBCCH PAT MCC MNC NOM TA RAC # Cell #
0637 1 - 4 234 05 2 00 0B
Column Description
BCCH ARFCN of BCCH carrier
G GPRS available ("1") or not available ("-") in currently used cell
PBCCH If PBCCH is present, indication of ARFCN, else ''-'' or if Frequency Hopping is used ''H''
PAT Priority Access Threshold (GSM Rec. 04.08 / 10.5.2.37b)
0 Packet access is not allowed in the cell
1 Spare, shall be interpreted as "000" (packet access not allowed)
2 Spare, shall be interpreted as "000" (packet access not allowed)
3 Packet access is allowed for priority level 1
4 Packet access is allowed for priority level 1 to 2
MCC Mobile Country Code
MNC Mobile Network Code
NOM Network Operation Mode (1...3)
TA Timing Advance Value
RAC Routing Area Code (as hexadecimal value)
To Next Page
Loading...
Need help?
General
