Siemens Brodersen MC55 AT - AT^SISE Internet Service Error Report

MC55_ATC_V04.00 Page 251 of 475 3/17/06
Confidential / Released
10.9 AT^SISE Internet Service Error Report
The AT^SISE write command returns the current error status of the specified Internet service profile. If the ser-
vice profile is not defined or the value is invalid "+CME ERROR" response is returned.
The error status is identical to the content of the "^SIS" URC last issued.
If a service fails the commands AT^SISR or AT^SISW will return an error response. However, if the AT^SISE
command returns <infoID>=0 it is recommended to use the AT+CEER command because a general GSM/
GPRS problem might be the reason.
Syntax
Parameter Description
Internet service profile identifier as defined by AT^SISS <srvProfileId>.
0...9
Reason for Internet service error. This is a subset of the <urcInfoId>s which can be found in Section 10.10,
Internet Service URC "^SIS".
The value 0 indicates there is no special Internet service error. In this case the application may use AT+CEER
to check for general GSM/GPRS problems.
Information text related to <infoID>. This is a subset of the <urcInfoText>s which can be found in Section
10.10, Internet Service URC "^SIS".
Note
• In particular cases, the AT^SISE command may deliver information and warnings. This applies the following
services:
FTP: Information 2100
POP3: Warnings
SMTP: Warnings
If an error occurs the information and warning messages are overwritten by error messages.
Test Command
AT^SISE=?
Response(s)
OK
Write Command
AT^SISE=<srvProfileId>
Response(s)
^SISE: <srvProfileId>, <infoID>[, <info>]
OK
ERROR
+CME ERROR: <err>
PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
! % % % % % ! ! !
<srvProfileId>
(num)
<infoID>
(num)
<info>
(str)