MC55_ATC_V04.00 Page 315 of 475 3/17/06
Confidential / Released
12.13 AT+FDT Data Transmission
This command requests the ME to transmit a Phase C page. When the ME is ready to accept Phase C data, it
issues the negotiation responses and the CONNECT result code to the application.
In Phase B, the AT+FDT command releases the ME to proceed with negotiation, and releases the DCS message
to the remote station. In Phase C, the AT+FDT command resumes transmission after the end of a data stream
transmitted before.
Syntax
Note
• Used for Fax Class 2 only.
Exec Command
AT+FDT
Response(s)
CONNECT
Write Command
AT+FDT=<df>, <vr>, <wd>, <ln>
Response(s)
CONNECT
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
EIA PN-2388 ! % ! % ! ! ! ! !
To Next Page
Loading...
