Siemens Brodersen MC55 AT - AT+CGQMIN Quality of Service Profile (Minimum Acceptable)

MC55_ATC_V04.00 Page 280 of 475 3/17/06
Confidential / Released
11.9 AT+CGQMIN Quality of Service Profile (Minimum acceptable)
Syntax
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context. If no minimum profile was explicitly
specified for a context, simply OK will be returned, but default values will be used for that context.
This command allows the TE to specify a minimum acceptable profile which is checked by the MT against the
negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local) context identification parameter,
<cid>.
A special form of the set command, AT+CGQMIN= <cid> causes the minimum acceptable profile for context
number <cid> to become undefined. In this case no check is made against the negotiated profile.
AT&F and ATZ will undefine the minimum QoS profiles of every context which is not active or not online.
Parameter Description
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Test Command
AT+CGQMIN=?
Response(s)
+CGQMIN: <PDP_type>, (list of supported <precedence>s), (list of supported <delay>s), (list of
supported <reliability>s), (list of supported <peak>s), (list of supported <mean>s)
OK
ERROR
+CME ERROR
Read Command
AT+CGQMIN?
Response(s)
[+CGQMIN: <cid>, <precedence>, <delay>, <reliability>, <peak>, <mean>]
[+CGQMIN: ...]
OK
ERROR
+CME ERROR
Write Command
AT+CGQMIN=[<cid>[, <precedence>[, <delay>[, <reliability>[, <peak>[, <mean>]]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge  Last
GSM 07.07 % % % % % % ! ! !
<cid>
(num)