Siemens Brodersen MC55 AT - Page 148

MC55_ATC_V04.00 Page 148 of 475 3/17/06
Confidential / Released
3 Voice followed by data, voice mode (only in connection with single numbering
scheme AT+CSNS)
4 Alternating voice/data, voice mode (only in connection with single numbering
scheme AT+CSNS)
5 Alternating voice/fax, voice mode (only in connection with single numbering
scheme AT+CSNS)
6 Voice followed by data, data mode (only in connection with single numbering
scheme AT+CSNS)
7 Alternating voice/data, data mode (only in connection with single numbering
scheme AT+CSNS)
8 Alternating voice/fax, fax mode (only in connection with single numbering
scheme AT+CSNS)
9 Unknown
0 Call is not one of multiparty (conference) call parties
1 Call is one of multiparty (conference) call parties
Phone number in format specified by <type>
Type of address octect
145 Dialing string <number> includes international access code character '+'
129 Otherwise
Alphanumeric representation of <number> corresponding to the entry found in phonebook; used character set
should be the one selected with command AT+CSCS (Select TE Character Set).
The maximum displayed length of <alpha> is 16 characters. If <alpha> has more than 16 characters, only the
first 15 characters are displayed. To indicate an overflow, a special character will be used as the 16th character.
This is a space if the character set selected with AT+CSCS is 'GSM', or 'E400' if the character set is 'UCS2'.
Due to time constraints on the necessary evaluation of the phonebook, this parameter may show a default value
in early call phases (e.g. for <stat>= ''dialing'', ''incoming'' or ''alerting''), even if a phonebook entry is present
for the number concerned.
Note
• Teleservices other than voice, data, fax are not fully supported by ME. They are used only in connection with
the handling for AT+CSNS, and may therefore occur in parameter <mode> for mobile terminated calls.
<mpty>
(num)
<number>
(str)
<type>
(num)
<alpha>
(str)(+CSCS)