Siemens Brodersen MC55 AT - Page 425

MC55_ATC_V04.00 Page 425 of 475 3/17/06
Confidential / Released
Parameter Description
Type of ring tone. You have a choice of 7 different ring tones and melodies. All will be played from the audio
output selected with the AT^SNFS command. <type>=0 is only intended for muting.
0 Mutes the currently played tone immediately.
1 Sequence 1
2 Sequence 2
3
(D)
Sequence 3
4 Sequence 4
5 Sequence 5
6 Sequence 6
7 Sequence 7
Volume of ring tone, varies from low to high
0
(D)
Mute
1Very low
2 Identical with 1
3Low
4 Identical with 3
5Middle
6 Identical with 5
7 High
Status of test ringing. Indicates whether or not a melody is currently being played back for testing
0 Switched off
1 Switched on
Notes
• Before first using ring tones note that the following settings apply:
We have chosen to let you decide your own preferences when you start using ring tones. Therefore, factory
setting is AT^SRTC=3,0,0 (ring tones are muted). To activate ring tones for the very first time, first enter the
write command and simply change the volume. After applying a firmware update the volume and type
selected before the firmware update will be preserved.
• The test ringing signal cannot be activated while an MTC is ringing (ERROR).
• If an MTC arrives during test playback, test ringing will be deactivated and "normal" ringing reactivated
(RING). Likewise, an MOC will also stop test ringing.
• If no optional parameter is entered, the old value will be kept.
<type>
(num)
<volume>
(num)
<status>
(num)