Siemens ET 200pro - Page 10

Table of contents
ET 200pro distributed I/O system
10 Operating Instructions, 03/2013, A5E00335544-08
4 Connection ........................................................................................................................................... 67
4.1 General rules and regulations for operating the ET 200pro ........................................................ 67
4.2 Operation of the ET 200pro with Grounded Reference Potential ............................................... 69
4.3 Electrical Configuration of ET 200pro ......................................................................................... 71
4.4 Technical specifications of the lines ............................................................................................ 77
4.5 Connecting the interface module to a CM IM DP Direct connection module .............................. 78
4.5.1 Requirements .............................................................................................................................. 78
4.5.2 Preparing PROFIBUS DP Cables ............................................................................................... 80
4.5.3 Preparing PROFIBUS Hybrid Cables for the Connection at CM IM DP Direct ........................... 81
4.5.4 Connecting PROFIBUS DP......................................................................................................... 84
4.5.5 Connecting the supply voltages .................................................................................................. 85
4.5.6 Terminating and installing the connection module ...................................................................... 86
4.6 Connecting the Interface Module to a CM IM DP ECOFAST Cu Connection Module ............... 87
4.7 Connecting the Interface Module to the CM IM DP M12, 7/8" Connection Module .................... 91
4.8 Connecting the IM 154-4 PN High Feature interface module with CM IM PN M12, 7/8" ........... 95
4.9 Connecting the IM 154-4 PN High Feature Interface Module with CM IM PN PP Cu ................ 99
4.10 Connecting the IM 154-4 PN High Feature Interface Module with CM IM PN PP FO .............. 103
4.11 Wiring the Electronic Module using the Connection Module .................................................... 107
4.11.1 Introduction................................................................................................................................ 107
4.11.2 Pin assignment for the Digital Electronic Modules .................................................................... 109
4.11.3 Pin assignment for the analog electronic modules ................................................................... 122
4.11.4 Connecting the connection module ........................................................................................... 129
4.12 Connecting the Power Module with the CM PM-E Direct Connection Module ......................... 130
4.13 Connecting the Power Module with the CM PM-E ECOFAST Connection Module ................. 132
4.14 Connecting the Power Module with the CM PM-E 7/8" Connection Module ............................ 134
4.15 Connecting the Outgoing Module with the CM PM-O PP Connection Module ......................... 136
5 Configuring .......................................................................................................................................... 139
5.1 PROFIBUS DP .......................................................................................................................... 139
5.1.1 Configuring in STEP 7 ............................................................................................................... 139
5.1.2 Configuring by Means of GSD File ........................................................................................... 140
5.1.3 Grouping electronic modules in the configuration ..................................................................... 142
5.1.3.1 Grouping Modules in Configuration Data (PROFIBUS DP) ...................................................... 142
5.1.3.2 Procedure in STEP 7 ................................................................................................................ 143
5.1.3.3 Procedure when using the GSD file .......................................................................................... 144
5.1.3.4 Example of a configuration........................................................................................................ 146
5.2 PROFINET IO ........................................................................................................................... 147
5.2.1 Configuring in STEP 7 ............................................................................................................... 147
5.2.2 Configuring by Means of GSD File ........................................................................................... 148
5.2.3 Assigning device names to the I/O device ................................................................................ 149
5.2.4 Grouping modules during configuration (PROFINET IO) ......................................................... 150
5.2.5 Configuring port 1 and port 2 .................................................................................................... 151