Siemens ET 200pro - Interface modules; Interface modules for PROFIBUS DP

ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
287
Interface modules
12
12.1
Interface modules for PROFIBUS DP
12.1.1
IM 154-1 DP interface module
Order number
6ES7154-1AA01-0AB0
Properties
The IM 154-1 DP interface module has the following properties:
● The interface module is installed on the bus module when supplied.
● The module connects the ET 200pro to PROFIBUS DP by means of the connection
module.
● The module prepares the data for the connected electronic modules.
● The module supplies the ET 200pro via the connection module with the 1L+
encoder/electronic supply and the 2L+ load voltage supply.
● The PROFIBUS DP address of ET 200pro can be set by means of the connection
module.
● The connection module can be used to activate/deactivate the terminating resistor of
PROFIBUS DP.
● IM 154-1 DP has a maximum address space of 244 byte for inputs, and 244 byte for
outputs.
● Operation as DPV0 slave
● Operation as DPV1 slave
– Diagnostic interrupts
– Hardware interrupts
– Swapping interrupts
● IM 154-1 DP supports operation with up to 16 electronic modules.
● Updating the interface module firmware
● Operation as DPV1 slave on Y Link
● Option handling
● Integrated power module for the 2L+ load voltage supply of ET 200pro