Siemens ET 200pro - LED Display on the Electronic Interface Module

Alarm, error and system messages
9.3 LED display on the power, electronic and pneumatic interface modules
ET 200pro distributed I/O system
238 Operating Instructions, 03/2013, A5E00335544-08
9.3.4
LED display on the electronic interface module
Introduction
The LED display for the pneumatic interface module is on the right side of the front panel.
LED display for the 16 DO 24 V DC CPV10 and 16 DO DC 24V CPV14 pneumatic interface modules
The figure below shows the position and layout of the LED display of the
16 DO DC 24V CPV10 and 16 DO DC 24V CPV14 pneumatic interface modules.
①
GE: Group error (red LED)
②
Status display (green LEDs)
Status and error LEDs of the pneumatic interface modules
Table 9- 13 Status and error displays of the pneumatic interface modules
LEDs
Meaning
Remedy
SF
Status and error
displays
On ---
Incoming diagnostic message
Analyze the diagnostic data.
No parameters or faulty
parameters
Check the parameter settings.
Off On (green LED)
Valve 0.0 (OUT0) to 1.7 (OUT15)
enabled
---