ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
139
Configuring in STEP 7
Introduction
The ET 200pro is listed in the hardware catalog of HW Config after you start STEP 7.
● STEP 7 Version 5.3 + SP3 or higher
● STEP 7, Version 5.3 + SP2 or higher and current HSP
1. Start SIMATIC Manager.
2. Create a new project.
3. Configure ET 200pro in HW Config.
4. Drag-and-drop the modules from the hardware catalog to the configuration table.
5. Double-click the first module of ET 200pro in the configuration table and set its
parameters.
6. Parameterize all other modules of ET 200pro.
7. Save the configuration, or download it to the DP master.
For further information, refer to the STEP 7 Online Help.
Commissioning ET 200pro (Page 153)
To Next Page
Loading...
