Siemens ET 200pro - Digital electronic module 4 DO DC 24 V;2.0 A (6 ES7142-4 BD00-0 AA0)

Digital electronic modules
14.4 Digital electronic module 4 DO DC 24V/2.0A (6ES7142-4BD00-0AA0)
ET 200pro distributed I/O system
344 Operating Instructions, 03/2013, A5E00335544-08
14.4
Digital electronic module 4 DO DC 24V/2.0A
(6ES7142-4BD00-0AA0)
Order number
6ES7142-4BD00-0AA0
Properties
● Digital electronic module with four outputs
● Output current per output 2 A
● Rated load voltage 24 V DC
● Suitable for solenoid valves, DC contactors and indicator lights
● Diagnostics of short-circuit outputs to M for each module
Note
The digital outputs at DQ
0
to DQ
3
(rated load voltage 2L+) can be switched off for safety-
related operation.
More detailed information is available in the Appendix in the chapter
Fail-safe
disconnection of ET
200pro standard output modules (Page 267).
Pin assignment of connection modules CM IO 4 x M12 and CM IO 4 x M12P
The table below shows the pin assignment of the 4 DO DC 24V/2.0A on the CM IO 4 x M12
and CM IO 4 x M12P connection modules.
View of circular connector
Terminal
Assignment X1 to X4
1
Not assigned
2
Not assigned
3
Ground for load voltage supply 2M
4 Output signal DQ
0
: Connector X1
Output signal DQ
1
: Connector X2
Output signal DQ
2
: Connector X3
Output signal DQ
3
: Connector X4
5 Functional earth (FE)